The Gear Works participates in Washington State’s Shared Work Program, enabling workers to reduce hours during difficult economic times while keeping pension and health benefits with unemployment payments to make-up for lost time.
We are proud to announce the installation of a new microhardness test center that will greatly increase The Gear Works’ ability to quickly and accurately determine carburized case depths for case hardened gears. The accurate determination of heat treat case depth is critical information required for precision gear manufacture. This state-of-the-art test equipment, produced by [...]
This 40,000 pound mining machine shaft required a 1-2 pitch crown spline on both ends. Each spline was cut to SAE Class 5 fit tolerances on our Pfauter P2500B Precision Gear Hobbing Machine. Our 20 ton Overhead Crane assisted in flipping the part.
With over 50 years of gearbox repair experience, let The Gear Works save you time and money over a new replacement. We repair virtually any make or model, with Hot Rush emergency breakdown service available if needed.
Specifically designed for Heavy-Duty, High-Precision
maximum productive gear manufacture.
* Maximum Work Diameter – 1600 mm
* Maximum Table Load – 18,000 Lbs
* Maximum Face Width – 1,000 mm
* Maximum Pitch – 18 Module (1.5 D.P.)
* Maximum Hob Diameter – 325 mm
At The Gear Works, we’re committed to continually improve our gear making capacity and quality. Call us [...]
Custom Designed Speed Reduction Gearbox for 10 Megawatt Generator Drive.
* Ratio: 4.9:1
* Input: 8900 RPM
* Output: 1800 RPM
* Load: 13,410 HP
* Power Source: Unique ramjet technology by Ramgen
Gearbox Specifications
* Rating – 1500 HP with 1.5 Service Factor
* Ratio – 35:1
* Torque – 3,151,250 Lb-In Output Continuous
* Input – Twin Planetary
* Speed – 30 RPM Output
* Weight – 46,000 Lbs.
For superior industrial transmissions, contact The Gear Works with your application requirements.
JUST INSTALLED – Model 3595 Gear Analyzer,
manufactured by M & M Precision Systems Corporation.
Workpiece Capacity:
* 0″-95″ outside diameter
* 20,000 lbs Table Load
* 48″ uninterrupted face width
* 50 DP-.5 DP Pitch range
* 61″ Between centers
Complete inspection of all Gear Elements:
* Runout
* Pitch Variation
* Accumulated Pitch Variation
* Profile/Involute
* Lead
* Slope error
* Tooth thickness
* Evaluation to AGMA, ISO [...]
The Gear Works proudly announces its New Crown Jewel. The ultimate in gear grinding technology has just been commissioned at our Seattle facility. Direct from Ludwigsburg, Germany, the Gleason-Pfauter P1600G Gear Grinding Machine is one of the most productive and accurate gear finishing machines ever produced.
Duplicating existing special drives by “Reverse Engineering” can be quicker and more cost effective than starting with a whole new fresh design. Especially if the original gearbox has had a successful service life.
